tecnotest EZ-SCAN 4000 Manuel D'utilisation page 52


EZ-SCAN 4000 ___________________________________________________________________________
•
The name of the Readiness Test will be displayed, followed by its status. Status is
either Completed, Not Completed, or Not Supported.
•
A down arrow on the screen indicates other test results. Use the
keys to view these other test results.
The following Readiness Tests are supported by the scanner:
CONTINUOUS
Misfire Monitoring
Fuel System Monitoring
Comprehensive
Component Monitoring
•
Press MON to exit the Readiness Test and display the opening screen.
View test results - OBD-II
•
[OBD-II] Your scanner must be connected, and the key in the ON position,
before viewing OBD-II Readiness Test data. If MON is pressed, and the vehicle
has not been scanned, the scanner will display Press the Scan key to Scan New
Data. Refer to "Scanning the Vehicle" on chapter 3.0.
•
Press POWER to display the EZ-Scan 4000 scanner opening screen.
•
Press MON to display Monitor menu. Use the
4- Test Results is highlighted, then press ENTER.
The Test Result will be displayed, followed by its status.
Each reading will give the Test Number, the Component Number, Pass or Fail
status, whether it is a "High" value or "Low" value test, the value reported by
the on-board computer, and the limit for that value. A down arrow on the
screen indicates other test results. Use the
other test results..
NOTE:
OBD-II equipped vehicles, are required to report the results of diagnostic tests for all
non-continuously monitored emissions related components, for instance the catalytic
converter or the EGR valve. These tests vary among manufacturers and the numbers
are assigned arbitrarily by them and should be listed in the service manual for the
vehicle.
•
Press MON to exit the Readiness Test and display the opening screen.
50
NON-CONTINUOUS
Catalyst Monitoring
Heated Catalyst Monitoring
Evaporative System Monitoring
Secondary Air System Monitoring
A/C System Refrigerant Monitoring
O Sensor Monitoring
2
O Sensor Heater Monitoring
2
EGR System Monitoring
and
and arrow keys to view these
OPERATING INSTRUCTIONS
and arrow
arrow keys until