Monitoring Real Time Data; View Freeze Frame Data - tecnotest EZ-SCAN 4000 Manuel D'utilisation

__________________________________________________________________________ EZ-SCAN 4000
3.2 -

Monitoring Real Time Data

•
Make sure the EZ-Scan 4000 scanner cable is correctly connected to the scanner
and to the vehicle, then press POWER.
•
Press DATA to display the Data menu. Make sure 1-Op Data is highlighted, then
press ENTER.
•
To toggle real-time monitoring ON and OFF, press MON.
•
An Initializing screen will be displayed while the scanner establishes a connection
to the computer/sensor.
•
When the connection has been made, the reference number in the upper right
corner will begin to flash.
NOTE:
If the communication link with the vehicle is broken during Monitor mode, the number
in the upper right corner will stop flashing.
•
Use the and
at a time.
•
When you are done viewing real-time data, press MON. The number in the lower
right corner will stop flashing.
•
Press DATA to exit Data mode and display the opening screen.
3.3 -

View freeze frame data

•
[OBD-II] Freeze Frame is only available on certain OBD-II vehicles.
•
Your vehicle must be scanned before viewing Freeze Frame data. If DATA is
pressed, and the vehicle has not been scanned, the scanner will display Press the
Scan key to Scan New Data. Refer to "Scanning the Vehicle" on chapter 3.0.
•
If the EZ-Scan 4000 scanner is not ON, press POWER to display the opening
screen.
•
Press DATA to display the Data menu. Press the
2-Freeze Frame is highlighted, then press ENTER.
NOTE:
If no Freeze Frame data is available, the scanner will display a No Freeze Frame Data
message, then display the Data Menu.
•
The Trouble Code which caused the Freeze Frame data to be captured will be
displayed on the screen.
A down arrow on the screen indicates more information. Use the
arrow keys to view the additional text.
Press ENTER to view Freeze Frame operation data.
OPERATING INSTRUCTIONS
or and arrow keys will step through the sensors a page
and arrow keys until
and

43