tecnotest EZ-SCAN 4000 Manuel D'utilisation page 49

__________________________________________________________________________ EZ-SCAN 4000
•
When the scanner is put in Capture Mode it is ready to capture real-time data
(for those problems that only seem to occur while driving). Press ENTER when the
intermittent problem occurs. The scanner will capture the data at the trigger point,
then will display a 'T' followed by seven '<' symbols as vehicle data after the
trigger is captured and stored.
NOTE:
You can press ENTER at any time, even if all seven '>' symbols are not displayed.
The scanner always keeps the most recent data while waiting for ENTER (trigger point)
to be pressed. Press MON at any time to abort the capture.
Capture Mode data can be viewed on the scanner, or you can use PC-Link to download
the data to your personal computer to save it and display it graphically. Data stored on
your computer can be used to keep a history of data for the vehicle.
•
Press POWER to display the EZScan 4000 scanner opening screen.
•
Press MON to display Monitor menu. [OBD-II] Make sure 1-Capture Mode is
highlighted, then press ENTER. [All] Use the
2-View Data is highlighted, then press ENTER.
•
Data from each sensor will be displayed on the screen. Use the
keys to view data changes as you move up and down the capture time line.
The (-) indicates time intervals before the trigger point, and (+) indicates time
intervals after the trigger point.
Use the
•
Press MON to exit Capture Mode and display the opening screen.
OPERATING INSTRUCTIONS
and arrow keys to view other sensors.
and arrow keys until
and

arrow
47