View Trouble Codes - tecnotest EZ-SCAN 4000 Manuel D'utilisation


EZ-SCAN 4000 ___________________________________________________________________________
3.4 -

View trouble codes

•
Your vehicle must be scanned before clearing trouble codes. If DATA is pressed,
and the vehicle has not been scanned, the scanner will display Press the Scan
key to Scan New Data. Refer to "Scanning the Vehicle" on chapter 3.0.
•
If the scanner is not ON, press POWER to display the opening screen.
•
Use the and
ENTER.
•
[OBD-II] vehicles read both Pending Codes (codes that have only been detected
once by the vehicle computer) and Trouble Codes (codes that have been detected
multiple times). Press ENTER to select either 1-Trouble Codes or 2-Pending
Codes.
•
If no Trouble Codes are in the vehicle's computer, No Trouble Codes Found will
be displayed.
If a Trouble Code is detected, the fault and its description will be displayed on the
scanner screen. The fault code number will be displayed in the upper left corner of the
screen.
•
A down arrow on the screen indicates more information. Use the
keys to view the additional text.
•
Use the and
44
arrow keys until 3-Trouble Codes is highlighted, then press
arrow keys to view any other Trouble Codes.
and arrow
OPERATING INSTRUCTIONS