WMF Kult Pro Mode D'emploi page 12

Cleaning and care Spiral cutter
Remove the mains plug after use. The motor unit (8) should never be placed in water, only wiped down
with a damp cloth. Never use abrasive cleaning agents. When cleaning the cutter inserts (5) and the
skewer support, be careful not to hurt yourself on the sharp blades and edges; Ideally, use the provided
washing-up brush (10), and you must always hold the cutter inserts (5) by the plastic parts. All
removable parts (stopper (1,3), collection container (9), filler tubes (2,4), cutter insert holders (6) and
cutter inserts (5)) can be placed in the dishwasher to make cleaning easier. However, we recommend
gently cleaning the cutter inserts (5) with warm running water and using a washing-up brush (10).
Regular washing in the dishwasher may blunt the blades.
Cleaning and care Juicer
Do not use harsh or abrasive cleaning agents.
Rinse all parts thoroughly in warm water.
Allow the parts to dry completely before reassembling them.
You can put the pressing cone (11,12), the strainer (13), the strainer holder (14), the spout (15) and the
jug (9) in the dishwasher for easy cleaning.
Important: Clean the strainer (13) and the spout (15) under warm water before placing in the dish-
washer by repeatedly pressing on the pump to rinse out the pulp residue.
22
Dishwasher safe
Stopper (1,3)
Collection container (9)
Filler tubes (2,4)
Cutter insert holder (6)
Cutter inserts (5)
Motor unit (8)
Jug (9)
Pressing cone (11,12)
Strainer (13)
Strainer holder (14)
Spout (15)
Can be rinsed Wipe with a
under running damp cloth
water
23