Useful Tips - WMF Kult Pro Mode D'emploi

Before using for the fi rst time Spiral cutter
Clean the device before use as described in the chapter on "Cleaning and Care".
1
3
4
2
5
6
7
8
▪ Turn the device off after cutting in order to fi ll it again.
Remove the mains plug once you are fi nished cutting. Take the cutter insert (5) out by pressing gently
from underneath (see picture).
Please note: The blades on the cutter inserts (5) are sharp; pick the cutter inserts up only by the
plastic parts.
20
▪ Place the the cutter insert holder (6) into the
motor unit (8).
▪ Choose the cutter insert (5) you want and stick it
into the rack (6).
Please note: The blades on the cutter inserts (5)
are sharp; pick the cutter inserts up only by the
plastic parts.
▪ Now place the appropriate fi ller tube (2.4) on the
cutting insert (5) and twist it in a clockwise direc-
tion until you feel it lock into place.
Note: If the fi ller tubes (2,4) are not locked
in place, it will not be possible to operate the
machine.
▪ Place the transparent collection container (9)
inside the appliance to collect the food after it has
been spiralised, grated or sliced.
▪ Now insert the mains plug into the socket.
▪ When using the appliance to spiralise: Now spear
the relevant piece of food onto the plunger (1).
Please note: The skewer support on the stopper
(1) has sharp edges.
▪ Insert the food, with the corresponding plunger
(1.3), into the fi ller tube (2.4). Make sure that the
food is centred as you insert it into the fi ller tube.
To switch the appliance on, press the start/stop
button (7).
Note: Only press lightly with the stopper (1,3)
onto the ingredients so that they are in contact
with the insert (5).
Initial operation Juicer
▪ Remove all packaging from the attachments.
▪ Clean the attachments before use as described in the "Cleaning and care" section.
▪ Place the transparent jug (9) inside the appliance to collect the pressed juice.
▪ Attach the strainer holder (14) to the spout (15) by twisting it slightly.
▪ Then insert the strainer holder (4) with the spout (15) into the motor unit.
▪ Insert the pressing cone (11,12) into the strainer (13), then insert the strainer (13) into motor unit
and twist clockwise to fi x it tightly. The appliance cannot be operated if the strainer (13) is not
locked in place.
Note: The small pressing cone (12) is located within the large
pressing cone (11). If the small pressing cone (12) is to be
used, press down on the two opposing recesses and pull off
the large pressing cone (11).
If the large pressing cone (11) is to be used, it should be
attached to the small pressing cone (12). It clicks into place.
▪ Now insert the mains plug into the socket.
▪ To switch the appliance on, press the start/stop button.
▪ Press the cut surface of the halved citrus fruit into the pressing cone (12, 13).
▪ The pressed juice fl ows through the spout in the jug via the strainer (13) which retains the pulp and
pips.
Note: Clean the strainer (13) regularly to prevent it from overfl owing.
▪ Switch the appliance off and then press the pressing cone (11,12) again for a few seconds at the
end so that the remaining juice can fl ow into the spout (15).

Useful tips

▪ Briefl y reduce the pressure on the stopper (1,3) at regular intervals during the cutting to stop end-
less spirals from being created. This way the vegetable noodles will be shorter and easier to portion
out.
▪ Wherever possible you should fi ll the fi ller tubes (2,4) vertically to get the best results.
▪ The more level the outer surface of the food is, the easier the endless spirals are to cut. For that
reason, food such as carrots should be sliced before cooking.
▪ Food with a diameter of more than 60 mm cannot be processed, however they can be made into a
round shape by cutting off the sides and then processed.
▪ We recommend a maximum chopping time of 2 minutes.
Removing Juicer
▪ Switch the appliance off and pull out the mains plug.
▪ Take the transparent jug (9) containing the pressed juice out of the appliance and place it on the
side.
▪ Remove the strainer (13) by gently twisting it anti-clockwise.
▪ Remove the strainer holder (14) along with the spout (15) by gently pressing from below.
21