Troubleshooting; No Sound; Sound Cuts-Out Unexpectedly - Arcam FMJ A29 Manuel

troubleshooting

If you are having trouble with your amplifier, check the
following items.

No sound

Check the following:
The amplifier is switched on.
<
The A29 is not muted (i.e. MUTE (mute) is not
<
shown on the display panel; the power LED is
showing green, not orange or red).
The selected source going in to the A29 is
<
generating audio (e.g., if CD is selected, then the
CD is playing).

Sound cuts-out unexpectedly

If the temperature of the internal heatsink rises above
a safe level, then a thermal cut-out inside the amplifier
operates to protect the unit and the protection system
temporarily removes power to the speakers. The system
will reset itself as the heatsink cools down.
With two pairs of low-impedance speakers
<
connected (6Ω or less), overloads are more likely.
Overloading the amplifier may cause it to shut
down because of overheating.
Note that, due to the high output voltage from some
<
CD players, it is possible to drive your amplifier
at full power even though the volume is not set at
maximum.
E-13