Elba P70 Mode D'emploi page 27

APPLYING THE SEALS
Turn the cooker top upside down.
Spread the longer seal "A" around the
left, rear and right sides as shown in
figure 4.6a.
With a cutter or a scissors cut the
excess seal "C" and retain it for next
use (figure 4.6b).
Spread the seal "B" around the left,
front and right edges of the cooker top
as shown in figure 4.6c.
Spread the seal "C" along the rear
edge of the cooker top as shown in fig-
ure 4.6d. Making sure that the begin-
ning and the end overlap at the seal "B"
(see figure 4.6e).
FASTENING THE
INSTALLATION BRACKETS
Each cooker top is provided with an
installation kit including brackets and
screws for fastening the top to fixture
panels from 2 to 4 cm thick.
Turn the cooker top upside down and
fasten the brackets "F and R" to the
appropriate socket holes, without tigh-
tening the screws "B" for the moment.
Make sure that the brackets are faste-
ned as shown in figures 4.7a, 4.7b and
4.7c.
FASTENING THE COOKER
TOP
Insert the cooker top into the hole and
position it correctly.
Adjust the position of the brackets "F
and R" and tighten screws "B" to block
the cooker top firmly in position.
With a sharp cutter or trimmer knife
trim the excess sealing material
around the edge of the cooker top.
Fig. 4.6a Fig. 4.6b
seal A
Fig. 4.6e
seal B
seal A
R
Fig. 4.7a
Rear side
seal C
seal A
B
R
Fig. 4.7b
Fig. 4.6c
seal C seal B
seal C
R
F
Fig. 4.7c
seal C
Fig. 4.6d
F
Front side
seal A
B
F
27