After-Cleaning Care - Bissell CROSSWAVE 2593 Serie Mode D'emploi

After-Cleaning Care

Go to support.BISSELL.com for a full list of how-to videos.
1.
Place the machine on the
3-in-1 Docking Station. Make
sure the solution in the clean
water tank reaches the Clean
Out Cycle line. If it does not, fill
tank with water to that line.
4.
Once the cycle is complete,
remove the brush roll by
grabbing the brush roll window
and pulling up. Pull the brush
roll tab to remove and put the
brush in the drying tray. The
brush and window can be hand
washed.
WARNING
electrical outlet before performing maintenance or troubleshooting on the dock.
2.
Make sure the water in the
dirty water tank is not over the
full line. If it is, empty the tank
and replace it before running
the Clean Out Cycle.
5.
Remove the machine from
the dock and wipe out the tray.
Do NOT rinse under faucet.
This keeps water out of the
charging plug.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
3.
Push the Clean Out Cycle
button to start the 40-second
cycle. Note: If the battery
runs out the Clean Out Cycle
cannot run until your machine
is docked for 30 seconds.
6.
Empty the dirty water tank.
To remove, press the button on
the top of the tank, grab the
front handle and pull tank out.
CONTINUED ON NEXT PAGE
BISSELL.com 9