Clearing Clogs; Maintenance & Care - Bissell 2763 Série Guide De L'utilisateur

Table des Matières

Publicité

Main n ce & Care
Maintaining the TurboBrush Tool and Pet TurboEraser Tool
The TurboBrush Tool should be checked regularly
for clogs or debris wrapping around the brush.
Select models include a Pet TurboEraser Tool that
follows the same maintenance instructions.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible, twist
the grey collar counterclockwise to remove the
faceplate and clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush. Please
ends of the brush in slots on sides.
5. Reposition the faceplate and secure by
twisting the grey collar clockwise.

Clearing clogs

Low suction or poor pickup may be due to
a clog in the vacuum cleaner. If you notice a
change in the sound of the motor or a reduction
in the spinning action, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Remove the secondary cyclone and check the
suction inlet for a clog.
5. Grasp the hose grip and lift to separate from
the suction opening. Check for a clog in the base
or the hose.
6. Release the Twist n' Snap hose from the
vacuum by turning to the left. Straighten the
hose and unclog with a long, narrow object such
as a broomstick.
7. If the low suction persists, follow the
instructions for checking the rotating brush on
page 10 and inspect the air passageway for
obstructions.
8. Check all filters for clogs. Refer to
Maintenance & Care on page 9.
www.BISSELL.ca
1-800-263-2535
12
2.
4.
7.
Air Passageway

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

9182 série

Table des Matières