If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way. www.BISSELL.ca 1-800-263-2535...
To reduce the risk of electric shock, turn danger of su ocation, keep away from you are familiar with all instructions and power switch o and disconnect polarized babies and children. operating procedures. plug from electrical outlet before performing maintenance or troubleshooting checks. www.BISSELL.ca 1-800-263-2535...
The switch will continue to glow if left on in the upright position or if the pod is detached from the vacuum base, although the brush will not reactivate until the pod is attached and the vacuum is detented. www.BISSELL.ca 1-800-263-2535...
The discharges are entirely place before removing pod or when using tools. harmless and are not associated in any way Placing the vacuum in its full upright position with the main power supply. automatically stops the rotating brush. www.BISSELL.ca 1-800-263-2535...
1. To move your vacuum cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward. 2. The vacuum can also be transported by grasp- ing the carry handle on the Lift-Off vacuum pod. www.BISSELL.ca 1-800-263-2535...
Page 8
Twist the cyclone counter-clockwise to unlock and pull straight down to remove. 2. The inner cyclone and dirt tank may be wiped clean with a damp cloth. Make sure all parts are dry before replacing. www.BISSELL.ca 1-800-263-2535...
This Febreze a waste basket to clear any accumulated dust filter is compatible with and debris. all BISSELL model series NOTE: The post-motor filter is a pleated filter. 2763 and 9182 vacuums. This filter is not washable and must be replaced For ordering information, when it becomes dirty.
Page 10
Remove any debris from this area. 7. Clean debris from the motor pulley and drive belt areas. 8. Check drive belt carefully for wear, cuts or stressed areas. If any damage is present, discard old drive belt and replace. www.BISSELL.ca 1-800-263-2535...
Page 11
Pulley NOTE: It is important that you use only genuine BISSELL replacement belts. Generic belts may not meet the exacting specifications required to keep your vacuum operating at its peak per- formance. The use of unbranded belts could...
7. If the low suction persists, follow the instructions for checking the rotating brush on page 10 and inspect the air passageway for obstructions. 8. Check all filters for clogs. Refer to Maintenance & Care on page 9. www.BISSELL.ca 1-800-263-2535...
Page 13
Please do performed by an authorized service representative. not return Thank you for selecting a BISSELL product. this product For any questions or concerns, BISSELL is happy to to the store. be of service. Contact us directly at 1-800-263-2535. www.BISSELL.ca 1-800-263-2535...
Deluxe Bare Floor Tool 160-1963 Pet Hair Fabric Tool 203-2447 TurboBrush Tool 160-1510 Pet TurboEraser Tool Febreze and related trademarks are owned by the Procter & Gamble Company, Cincinnati, Ohio and used under license by BISSELL Homecare, Inc. www.BISSELL.ca 1-800-263-2535...
BISSELL Consumer Care. Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new or Website or E-mail: remanufactured components or products), at BISSELL’s option, free of www.BISSELL.ca...
Page 16
Sunday 10 am - 7 pm ET Visit the BISSELL website: www.BISSELL.ca When contacting BISSELL, have model number of cleaner available. Please record your Model Number: ___________________ Please record your Purchase Date: ___________________ NOTE: Please keep your original sales receipt. It provides proof of purchase date in the event of a warranty claim.