Hilti TE 70-AVR Mode D'emploi page 13

or generator must always be within +5 % and -15 % of the rated voltage of
the tool.
Weight
Single impact
energy in ac-
cordance with
EPTA procedure
05
Hammer drill
bits, Ø
Hammer drill
bits, Ø
Ø drill bits for
wood
Ø drill bits for
wood
Ø drill bits for
metal
Ø drill bits for
metal
4.1 Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord
or extension cord if damaged while working. Disconnect the supply cord
plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced
by a qualified specialist if found to be damaged.
• Use only extension cords of a type approved for the application and
with conductors of adequate gauge (cross section). The power tool
may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and
correspondingly marked for this application.
*2063039*
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
TE 70­AVR
18.3 lb
(8.3 kg)
11.5 J
1/2 in ...
2 3/16 in
12 mm ...
55 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
2063039
TE 70-ATC/AVR TE 80-ATC/AVR
20.9 lb
(9.5 kg)
11.5 J
1/2 in ...
2 3/16 in
12 mm ...
55 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
21.4 lb
(9.7 kg)
11.5 J
1/2 in ...
2 3/16 in
12 mm ...
55 mm
13/32 in ...
1 1/4 in
10 mm ...
32 mm
0 in ... 23/32 in
0 mm ... 20 mm
English 9