Disposal Of Electrical And Electronic Equipment - Mettler Toledo 64060625 Manuel D'installation

DO NOT REPLACE THE BATTERY PACK WITH A BATTERY OR BATTERY PACK OTHER THAN THE ONE
SUPPLIED BY METTLER TOLEDO SPECIFICALLY FOR THE IND560x OR IND226x WITHOUT FIRST MAKING
SURE THE ENTITY PARAMETERS ARE ACCEPTABLE. IF THERE IS ANY DOUBT REGARDING THE ENTITY
PARAMETERS, USE ONLY THE BATTERY PACK SUPPLIED BY METTLER TOLEDO.
DISCONNECT AND REMOVE THE BATTERY PACK FROM THE HAZARDOUS AREA BEFORE TESTING THE
BATTERY VOLTAGE. DO NOT TEST BATTERY VOLTAGE WITHIN A HAZARDOUS AREA.
BEFORE CONNECTING/DISCONNECTING ANY INTERNAL ELECTRONIC COMPONENTS OR
INTERCONNECTING WIRING BETWEEN ELECTRONIC EQUIPMENT ALWAYS REMOVE POWER AND WAIT AT
LEAST THIRTY (30) SECONDS BEFORE ANY CONNECTIONS OR DISCONNECTIONS ARE MADE. FAILURE TO
OBSERVE THESE PRECAUTIONS COULD RESULT IN DAMAGE TO OR DESTRUCTION OF THE EQUIPMENT
AND/OR BODILY HARM.
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES.

Disposal of Electrical and Electronic Equipment

In conformance with the European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies to
countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting point specified
for electrical and electronic equipment.
If you have any questions, please contact the responsible authority or the distributor from which you
purchased this device.
Should this device be passed on to other parties (for private or professional use), the content of this
regulation must also be related.
Thank you for your contribution to environmental protection.
WARNING
WARNING
CAUTION
NOTICE