EdilKamin FANTASY Installation, Usage Et Maintenance page 34

1st SOLUTION: KIT 11 (code 645700) - ADJACENT ROOM ONLY
Note: THE PIPES ON THE HOT AIR OUTLETS MUST BE FITTED BEFORE APPLYING THE COVERINGS AND
PRIOR TO DISASSEMBLY OF THE UPPER CAST IRON SIDE FLANK. THE FIRST PART OF THE FLEXIBLE
PIPE MUST BE COMPLETELY "RELAXED" IN SUCH AWAY TO ELIMINATE CORRUGATION. IN THIS WAY,
THE INTERNAL DIAMETER WILL BE SLIGHTLY ENLARGED TO FAVOUR ENTRANCE.
- De ne the position of the stove with respect to the walling ( g. a).
- Disassemble the upper part of the back (132) and remove one of the two predrilled caps in correspondence with the hot air outlet
pipes ( g. b).
- Activate the hot air channelling control lever (13), removing the locking plate (133) ( g. b).
- Cut the ue cover to size (6) on the wall side ( g.c)
- Place the stove in its de nite position.
- Extend the aluminium pipe (3) for hot air channelling, without connecting the stove outlet.
- Fit the medallion (5) on the aluminium pipe and the pipe cover (6a) without locking it in ( g. c).
- Fit the aluminium pipe to the hot air outlet on the back of the stove (8) ( g. d).
- Replace the upper part of the back (132).
- Place the pipe cover (6) in the de nite position and fasten it to the back of the stove with the supplied screws (7) ( g. d).
- Install the terminal outlet (4) and its aluminium pipe (3) ( g. d).
- Fasten the wall medallion (5) with silicone ( g d).
g. a
g. c
6
6a
g. d
8
1 Box
3 Ø 10 pipe
4 Smoke outlet end-piece
5 Wall medallion
6a Flue cover
7 Flue cover fastening screws
8 Pipe blocking clamp
INSTALLATION
g. b
3
2
5
8
8
5
4
4
7
6
6a
132
133
13
132
4
8
5
3
6
- 34
-
1
5
4
7
3
6
6a
8
n° KIT 11
1 645740
1 162520
1 293430
1 644190
1 645730
4 168260
2 46160