EdilKamin FANTASY Installation, Usage Et Maintenance page 31

COVERING INSTALLATION FATA/SIRENA
62
n°2 viti
2 screws
DETAIL. X
Part. "X"
g. 12
g. 1
62
DETAIL. Z Part. "Z"
62
bushings
24
vite
screw
g. 2
*
g. 4
*
COVERING INSTALLATION STORY
24
62
62
4
62
62
62
n°2 viti
2 screws
24
DETAIL. X
Part. "X"
g. 3
140
ASSEMBLING THE CERAMIC TOP FATA/SIRENA ( g. 13)
140
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (140)
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
• the red enamel with crystalline, applied to the majolica,
crazes (cracks) evenly over the whole surface. Crazing is not
a defect but is a characteristic of enamel applied to majolica
known as "craclè".
• The ceramic parts (majolica) are cast and enamelled
manually and may present small defects that will not
g. 13
affect their quality (small dents or enamel porosity), but instead
testi es to their manual manufacture.
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 at washers diam. 6
2 bushings
The stove comes furnished with its lateral metal side
panels already assembled, while its ceramic upper and
lower front panels (62) and top (140) must be assembled
as follows:
ASSEMBLING THE UPPER FRONT PANEL ( g. 1-2)
• Position the ceramic upper front panel (62) so that it rests
against the front panel support (24) positioned above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
NOTE:
For correct assembly of the upper front panel (62), place the
bushing supplied between the same and the front panel (24), as
shown in detail "Z" in Illustr. 2.
ASSEMBLING THE LOWER FRONT PANEL ( g. 1-3)
• Use the supplied Allen key to loosen the screws that hold
the cast iron lower front grill (4) in place and remove it.
• Position the front panel (62) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws as indica-
ted in detail "X" ( g. 3).
ASSEMBLING THE CERAMIC TOP ( g. 4)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (140)
• Where necessary, af x the supplied washer between the sili-
cone spacer and cast iron top.
- 31
-