EdilKamin FANTASY Installation, Usage Et Maintenance page 33

g. A
g. B
P
g. C
P
L
g. D
g. E
INSTALLATION
hot air outlet pipes
P
P
L
front
middle
rear
- 33
HOT AIR CIRCULATION
In the installation area, the hot air is emitted through the
grill installed in the upper front portion ( g. E).
To channel the hot air in one or two adjoining rooms, the
stove is equipped with two pipes on the back ( g.A), to
which special aluminium pipes must be connected.
KIT 11 and KIT 11 BIS optional are available to facilitate
air distribution (see page 34-35-36).
It is essential to remember the importance of proper insulation
on the pipe where the hot air passes to avoid
dispersion. Avoid curves in the pipe as much as possible.
Note: THE PIPES ON THE HOT AIR OUTLETS
MUST BE FITTED BEFORE APPLYING THE
COVERINGS AND PRIOR TO DISASSEMBLY OF
THE UPPER CAST IRON SIDE FLANK. THE
FIRST PART OF THE FLEXIBLE PIPE MUST BE
COMPLETELY "RELAXED" IN SUCH AWAY TO
ELIMINATE CORRUGATION. IN THIS WAY, THE
INTERNAL DIAMETER WILL BE SLIGHTLY
ENLARGED TO FAVOUR ENTRANCE.
Channelled air distribution is adjustable manually by
means of the "L" lever ( g.D).
To move, remove the "P" locking plates fastened with
screws ( g. B-C).
Once the plates have been removed, hot air can be directed
either in the upper front panel part g. E (lever pulled
all the way back - see g. D) or in the rear part g. F
(lever pulled all the way forward - see g. D) or half in
the upper front panel part and half in the rear part (lever
in the middle - see g. D).
Note: IF THE STOVE IS NOT CHANNELLED, THE
PLATES (P) MUST NOT BE REMOVED.
g. F
-