Ribimex Ribiland PRS660 Manuel D'instructions Et D'utilisation page 22

6.2- Changing the grinding disk
1. Disconnect machine from its power source.
2. Remove lateral disk guard (2).
3. Remove disk flange
4. Remove used disk and fit a new grinding disk (refer to dimension characteristics)
5. Fit the disk flange and tighten screw.
6. Replace additional disk guard.
7. Ensure that the whole assembly is tight.
8. Warning! Do NOT use grinding wheels that are worn, broken, cracked or damaged.
Use only original grinding wheels or grinding wheels recommended by tool manufacturer.
6.3- Service
a) Have your tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
b) Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts; otherwise this may result in considerable
danger to the user.
c) Maintain tool with care
Keep tool clean for better and safer performance.
6.4- Storage
Store product, instructions manual and accessories in its original packaging.
Product must be stored in a clean, dry location. Always lock up product and keep out of reach of
children.
6.5- Disposal
Do not dispose with household garbage. Do not throw into the environment.
Dispose of the tool in a collection centre for waste of electrical and electronic equipment, or a waste
drop-off centre; or seek advice from your local municipality.
7- Warranty Information
The manufacturer or its authorised representative provides warranty in accordance with the
legislation of the customer's own country of residence, with a minimum of 1 year, starting from the
date on which the appliance is sold to the end user.
The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service centre.
When making a claim under the warranty, the original bill of purchase (with purchase date) must be
submitted.
The warranty will not apply in cases of:
- Normal wear and tear
- Incorrect use, e.g. overloading of the appliance, use of non-approved accessories
- Use of force, damage caused by external influences
- Damage caused by non-observance of the user manual, e.g. connection to an unsuitable mains
supply or non-compliance with the installation instructions
- Partially or completely dismantled tool.
- Partially or completely modified tool with parts not recommended by the manufacturer.