Ribimex Ribiland PRS660 Manuel D'instructions Et D'utilisation page 17

The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above.
24. Special safety guidelines
24.1. Check the grinding disk before use for possible damages. Do not use grinding disks that are
cracked, torn or damaged
24.2. Check that the rotation speed given on the disk is greater than or equal to the rated speed of the
machine
24.3. The grinding disk must be securely installed with the mounting nut.
24.4. The screws on the protective device must be properly screwed on.
24.5. The spark protecting cover must be set in the appropriate position to avoid any hazard to the
user.
24.6. A disk that is already damaged or deformed should not be further used.
Use only original grinding disk, which is delivered or recommended by the manufacturer.
25. Handling, transport and storage of grinding disks:
Grinding disks are fragile, as well as sensitive to impact and shocks.
Therefore special precautions are necessary:
a) do not let the grinding disk fall and avoid impacts effects.
b) do not use a dropped or damaged disks.
c) Avoid vibrations or vibrations during application
d) avoid damaging the mounting bore
e) Avoid loads on the sharpening surface
f) store grinding disks flat or perpendicularly, keep dry, protected from frost and at a constant and
medium temperature.
g) Keep the grinding disks in their original packaging or in special containers and on shelves.
3.2- Safety warnings regarding the use
Important notice! Observe any national safety regulations regarding installation, operation and
maintenance.
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the machine.
5. Do not use tool if damaged, eccentric or vibrating.
6. Do not use damaged, cracked, eccentric or vibrating disks.
7. Never seize or touch the disk during operation
8. Position power cable in a way that it is not trodden on or damaged during use.
9. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
10. Grinding may create dust and projection of debris. Wear appropriate protective equipment (dust
mask, safety goggles...).
Use dust extraction device when available, and ensure that it is properly connected and used.
11. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.