Ribimex Ribiland PRS660 Manuel D'instructions Et D'utilisation page 18

c. Health defects resulting from vibration emission if the power tool is being used over longer period
of time or not adequately managed and properly maintained.
d. Bruising hazard if the grinding wheel is touched while in operation.
e- Exposure to electricity by using a non-standard defective electrical connection lines.
12. WARNING!
This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal
injury, we recommend persons with medical implants to consult their physician and the medical
implant manufacturer before operating this machine.
13. The declared vibration total value has been measured in accordance with a standard test method
and may be used for comparing one tool with another, especially applicable when other tool as same
construction and is operated with same power supply.
The declared vibration total value may also be used in a preliminary assessment of exposure.
14. Warning: The vibration emission during actual use of the power tool can differ from the declared
total value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
15. WARNING
A certain level of noise emitted from this machine is not avoidable.
Plan noisy work according to local laws and at specific times.
Keep rest periods and if necessary restrict the working hours to a minimum.
For your own personal protection and the protection of bystanders have suitable hearing protection
worn.
IV- GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Presentation
The saw-chain grinding machine is delivered pre-assembled.
One part consists of the base, on which the chain guide is located.
The other part is a bearing arm with the motor and handgrip.
4.3- Assembly
4.3.1- Installation
1. The assembly shall be performed with the machine unplugged!
2. The machine design allows for either a desk installation or wall mounting.
Place machine on a flat, stable and solid surface.
- When installing it on the desk: put the machine on the edge of the desk up to the stop limit (see Fig.1)
and screw it to the desk using the holes (18) in the base
- When mounting on the wall: place the machine on the wall and screw it to wall using the respective
holes (19) in the vertical part of the base.
Important, at this stage, a distance from the wall should be kept or spacers should be used for an
access to the rear set screw to be preserved.
Tips: When mounting on the wall, take care to mount the machine at a height of 120-130cm from the
floor to avoid working at eye height!