English
12
1 Remove the mains plug from the wall socket.
2 Wipe the outside of the coffeemaker with a damp cloth.
3 Clean the filter basket and the permanent filter with hot water and some washing-up liquid or
clean them in the dishwasher.
Cleaning the grinder funnel
Important: Clean the grinder funnel every 1 to 2 weeks to prevent clogging with ground coffee. This
is easily and quickly done by following the steps below.
Note: Make sure the coffee bean container is empty before you start the cleaning procedure.
1 Press the on/off button to switch off the appliance (Fig. 21).
2 Open the filter basket holder (Fig. 14).
3 Place a paper filter (type 1x4 or no. 4) or the permanent filter in the filter basket (Fig. 15).
4 Close the filter basket holder.
5 Use the end of the bean chute cleaning brush to open the grinder funnel lid (Fig. 22).
6 Press and hold the strength select button for 4 seconds (Fig. 23). The grinder starts cleaning itself.
7 When the grinder has stopped cleaning, use the bean chute cleaning brush to brush ground coffee
residues into the lower part of the funnel (Fig. 24). The ground coffee residues fall into the filter
basket.
8 Close the lid of the grinder funnel.
9 Remove the paper filter or permanent filter with the ground coffee residues.
Descaling the coffeemaker
Descale the coffeemaker when you notice excessive steaming or when the brewing time increases. It
is advisable to descale the coffeemaker every two months. Only use white vinegar to descale, as other
products may cause damage to the coffeemaker. For more information on descaling, see
www.philips.com/descale-coffeemaker.
Warning: Never use vinegar with an acetic acid content of 8% or more, natural vinegar,
powder descalers or tablet descalers to descale the appliance, as this may cause
damage.
1 Open the water reservoir lid.
2 Fill the water reservoir with white vinegar (4% acetic acid) up to the 10-cup indication.
3 Place a paper filter (type 1x4 or no. 4) or the permanent filter in the filter basket and close the filter
basket holder.
4 Put the empty jug in the appliance.
5 Put the mains plug in the wall socket.
6 Press the on/off button to switch on the appliance (Fig. 9). The display lights up.
7 Press the strength select button and turn the control knob to choose the pre-ground coffee setting
(Fig. 11).
8 Press the center of the control knob to confirm (Fig. 6).
9 Press the center of the control knob again to start the brewing process.
10 Wait until half of the vinegar has flowed into the jug. Then press the on/off button to interrupt the
brewing process. Let the vinegar act for at least 15 minutes.
11 Press the on/off button to switch the coffeemaker back on.
12 Press the center of the control knob twice to let the appliance complete the brewing process (Fig.
25).