What To Do If The Descaling Procedure Is Interrupted; Warning Icons And Error Codes; Meaning Of The Warning Icons - Philips Saeco PicoBaristo SM5479 Mode D'emploi

English
16
11 The second phase of the descaling cycle, the rinsing phase, starts and lasts 3 minutes. The display
shows the rinsing icon and the duration of the phase.
12 Wait until the machine stops dispensing water. The descaling procedure is finished when the tick
appears on the display.
13 Press the OK button to exit the descaling cycle. The machine starts heating up and performs the
automatic rinsing cycle.
14 Clean the milk carafe after descaling (see 'Weekly cleaning of the milk carafe').
15 Clean the brew group after descaling (see 'Cleaning the brew group under the tap').
16 Place a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!

What to do if the descaling procedure is interrupted

You can exit the descaling procedure by pressing the on/off button on the control panel. If the
descaling procedure is interrupted before it is completely finished, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine
back on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding
ground coffee.
Note: If the descaling procedure was not completed, the machine will require another descaling
procedure as soon as possible.

Warning icons and error codes

Meaning of the warning icons

Meaning of the warning icons
The warning icons are displayed in red. Below you find a list of the warning icons that may appear on
the display and their meaning.
Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The milk carafe is not installed.
Insert the milk carafe into the
machine.
INSERT CARAFE
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee grounds
container.
The brew group is blocked by
coffee powder. Clean the brew
group.