NSK Ti-Max X450L Manuel D'opération page 6

X450L / X450 (1) Connecting
1) Insert the handpiece into the Coupling.(Fig. 2)
2) Make sure the handpiece is fully seated in the coupling.
(2) Disconnecting
Pull back the Retention Lock Ring and remove the handpiece from the Coupling.(Fig. 2)
CAUTION
Do not operate the Retention Lock Ring while pressurized. This may cause the handpiece to shoot off
of the coupling unexpectedly.
X450M4 / X450 5H (1) Connecting
1) Insert the handpiece correctly into the hose connector and tighten the hose
nut.(Fig. 3)
2) Make sure the handpiece is securely connected to the hose.
(2) Disconnecting
Loosen the Hose Nut and remove from the Hose.
Retention Lock Ring
Handpiece Coupling
Fig. 2
Tighten
Handpiece Hose Nut
Fig. 3
5