Using The Tool - Ega Master 56586 Serie Mode D'emploi

ENGLISH
NOTICE
Series 56586, 56573, 56587, 56588, 56589, 56590 and 56591 Low Profile Hydraulic Torque
Wrenches are designed for installing and removing large bolts having minimal wrench clearance
at offshore platforms, power plants, steel erection sites and other locations requiring precise
high torque during bolt makeup and maximum torque for bolt breakdown.
The manufacturer is not responsible for customer modification of tools for applications on
which the manufacturer was not consulted.
WARNING
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THIS
MANUAL INTO THE HANDS OF THE OPERATOR.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
• Always operate, inspect and maintain this tool in accordance with American National
Standards Safety Code for Hydraulic Rams and Jacks (ANSI B30.1)
• This tool will function using an air or electric powered hydraulic pump. Adhere to the pump
safety require ments and follow instructions when connecting the pump to the tool.
• Use only equipment rated for the same pressure and torque.
• Use only a hydraulic pump capable of generating 10,000 psig (681 bar) maximum pressure
with this tool.
• Use only twin line hydraulic hose rated for 10,000 psig (681 bar) pressure with this tool.
• Do not interchange the male and female swivel inlets on the tool or the connections on one
end of the hose. Reversing the inlets will reverse the power stroke cycle and may damage
the tool.
24

USING THE TOOL