Replacement Of The Blade - Ega Master 63083 Manuel D'instructions

To change the blade you will need the following material:
- 10mm socket wrench.
- PH-1 screwdriver.
Steps:
1. Remove the 7 screws of the outside cover.
2. Remove the 4 screws and four nuts shown in the image.
3. Remove the cover.
4. Remove the 4 gears carefully and considering where and how each of them goes.
5. Remove the three screws shown in the picture.
6. Once removed the screws in point 5, remove the four nuts and spring shown in picture 6.
The blade is ready to be replaced.
1
4
The cutter is in ON position but the blade does not work properly:
Problem:
- The cutter does not have enough power or the battery is running low.
Solution:
- Charge the battery.
8

REPLACEMENT OF THE BLADE

2
5
SOLUTION FOR POSSIBLE PROBLEMS
3
6