Xtender Manual - Scubapro XTENDER Mode D'emploi

XTENDER MANUAL

Thank you for purchasing Xtender, and welcome to SCUBAPRO. Starting today,
you'll be accompanied on all your dives by a computer featuring advanced
technology for dives in complete safety.
Notes about safety
Like all dive computers, Xtender gives the diver information, but it doesn't provide
the concepts required to interpret and use this information in a practical way. Dive
computers are no substitute for good sense and a suitable dive training course.
Before using your Xtender dive computer, carefully read and understand the
information provided in this manual.
! CAUTIONS
Scuba diving entails certain risks. Even if you carefully follow the instructions
provided in this manual, potential risks will remain regarding decompression
sickness, oxygen toxicity, and other risks related to diving with Nitrox mixtures or
compressed air. If you are not fully aware of these risks, and if you do not accept
full responsibility for them, do not use Xtender.
Xtender is only programmed for dives using nitrox (max. 99% O ) and compressed
2
air (21% O ). Do not use Xtender for dives with mixtures of other gases.
2
Before diving, always check the level of O set, and compare it with the gas
2
mix that you will be using. Always keep in mind that entering the wrong mixture
will result in calculations of insuffi cient decompression time or calculation of an
oxygen toxicity value that is too low. The maximum difference of the mixture
measured must not exceed 1% O . The wrong gas mixture can be deadly!
2
2