Cleaning Instructions; Grounding Instructions; Extension Cords - Weston Realtree OUTFITTERS 75-0301-RT Mode D'emploi

CLEANING INSTRUCTIONS

WARNING!
is unplugged and the Power Switch is set to the "OFF" position.
Clean the Trays and inside of the Cabinet before using the Dehydrator for the first
time and after each use.
1. Set the Power Switch to the "OFF" position. Disconnect the electrical cord from
the outlet.
2. Allow the Dehydrator to completely cool before cleaning.
3. Remove the Trays from the Dehydrator Cabinet.
4. Wipe the Dehydrator Cabinet clean (inside and out) with a damp sponge or soft
washcloth. Be careful not to splash water onto the Heating Element (located behind
the Screening and the Fan in the back of the Cabinet) while cleaning the inside of
the Cabinet. Water could damage the Heating Element and increases the risk of
electric shock. DO NOT immerse the Dehydrator in water.
5. Clean the Dehydrator Trays with warm, soapy water. Rinse with clear water and
dry immediately.

GROUNDING INSTRUCTIONS

GROUNDING
This appliance must be grounded while in use to
protect the operator from electric shock. The appliance
is equipped with a 3-conductor cord and a 3-prong
grounding type plug to fit the proper grounding-type
receptacle. The appliance has a plug that looks like
Figure A. An adaptor, Figure B, should be used for
connecting Figure A plugs to two-prong receptacles.
The grounding tab which extends from the adaptor
must be connected to a permanent ground such as
a properly grounded outlet box as shown in Figure C
using a metal screw. DO NOT modify the plug in
any way.

EXTENSION CORDS

. Use only 3-wire extension cords which have
3-prong grounding-type plugs and a 3-pole cord
connector that
appliance.
.
Use only extension cords having an electrical
rating not less than the rating of the appliance.
.
DO NOT use damaged extension cords. Examine
extension cord before using and replace if
damaged.
.
DO NOT abuse extension cord and do not yank on
any cord to disconnect.
heat and sharp edges. DO NOT allow the cord to
drape over the edge of the workspace.
Before cleaning or servicing the Dehydrator, make sure it
accepts the plug
Keep cord away from
Grounding
Prong
Grounding
Conductor
Metal
Grounding
Screw
from the
Cover of
Grounded
Outlet Box
Grounding
Means
AA2220
-5-
Figure A
Circuit
Figure B
Figure C