Cleaning Instructions - Weston 83-0750-W Mode D'emploi

CLEANING INSTRUCTIONS

Electrical Shock Hazard. Before cleaning, assembling, or
w WARNING
disassembling the appliance, make sure the appliance is
OFF( ) and the plug is removed from the outlet/power source.
Sharp Blade. Handle carefully. Keep fingers away from the
w CAUTION
blade. Never feed food by hand. Always use the food pusher.
Always use completely assembled meat slicer with food
carriage and food pusher. Protective, cut-resistant Kevlar
gloves are recommended whenever handling the blade.
1. Always disconnect the Meat Slicer from the power source before cleaning.
2. Never immerse the Motor Assembly of the Meat Slicer in water or other
liquid.
3. The Blade, Blade Protector, Food Pusher, and Food Tray can all be hand
washed in hot soapy water. Because these parts come in contact with food,
they should be sanitized properly. Allow sanitized parts to air dry. Do not use
harsh abrasives to clean any part of the Meat Slicer. Use extreme caution
when handling or cleaning the Blade, as it is extremely sharp! Do not leave
Blade underwater; trying to handle sharp objects in water can be hazardous.
It is highly recommended to wear cut-resistant Kevlar Gloves when removing,
cleaning and re-installing the Blade.
4. Rotate the Thickness Adjustment Knob all the way to the "-" position.
5. Remove the Food Pusher and rotate
the Sliding Food Carriage out of the way in
order to allow for easy access to the Blade.
6. To remove the Blade hold the Blade
with one hand and use a coin or small
flathead screwdriver to unlock the Blade
Locking Screw by gently turning it clockwise
(FIGURE 5). Carefully pull the Blade off and
hold it by using the hole in the center of the
Blade.
7. Gently remove the Blade Protector. If too
much pressure is applied to either end, you
may risk breaking the protector.
8. Clean the outer surface of the Meat
Slicer Body/Motor with a damp cloth. Mild
detergent or water can be used to dampen the cloth. Wipe away from the
Blade, Never wipe toward the Blade. Never immerse Body/Motor in water or
any other liquid. Do not use steel wool, abrasive cleaners, or sharp utensils to
clean.
9. After cleaning and drying, reinstall the Blade Protector, Blade, and Blade
Screw to the Body/Motor. Make sure the Blade Locking Screw is properly
tightened. Rotate the Blade Locking Screw counter-clockwise to tighten.
Rotate the Sliding Food Carriage back to its proper position and re-install the
Food Pusher.
CAUTION SHARP
Blade
Blade
Locking
Screw
FIGURE 5
9