Cleaning Instructions - Weston 83-0750-W MS01 Mode D'emploi

CLEANING INSTRUCTIONS

Electrical Shock Hazard. Before cleaning, assembling, or
w WARNING
disassembling the appliance, make sure the appliance is
OFF( ) and the plug is removed from the outlet/power source.
Sharp Blade. Handle carefully. Keep fingers away from the
w CAUTION
blade. Never feed food by hand. Always use the food pusher.
Always use completely assembled meat slicer with food
carriage and food pusher. Protective, cut-resistant Kevlar
gloves are recommended whenever handling the blade.
1. Always disconnect the Meat Slicer from the power source before cleaning.
2. Never immerse the Motor Assembly of the Meat Slicer in water or other
liquid.
3. The Blade, Food Pusher, and Food Tray can all be hand washed in hot
soapy water. Because these parts come in contact with food, they should be
sanitized properly. Allow sanitized parts to air dry. Do not use harsh abrasives
to clean any part of the Meat Slicer. Use extreme caution when handling or
cleaning the Blade, as it is extremely sharp! Do not leave Blade underwater;
trying to handle sharp objects in water can be hazardous. It is highly
recommended to wear cut-resistant Kevlar Gloves when removing, cleaning
and re-installing the Blade.
4. Rotate the Thickness Adjustment Knob all the way to the "-" position.
5. Remove the Food Pusher and rotate
the Sliding Food Carriage out of the way in
order to allow for easy access to the Blade.
6. To remove the Blade hold the Blade
with one hand and use a coin or small
flathead screwdriver to unlock the Blade
Locking Screw by gently turning it clockwise
(FIGURE 5). Carefully pull the Blade off and
hold it by using the hole in the center of the
Blade.
7. Clean the outer surface of the Meat
Slicer Body/Motor with a damp cloth. Mild
detergent or water can be used to dampen
the cloth. Wipe away from the Blade, Never
wipe toward the Blade. Never immerse
Body/Motor in water or any other liquid. Do
not use steel wool, abrasive cleaners, or sharp utensils to clean.
9. After cleaning and drying, reinstall Blade and Blade Screw to the Body/
Motor. Make sure the Blade Locking Screw is properly tightened. Rotate the
Blade Locking Screw counter-clockwise to tighten. Rotate the Sliding Food
Carriage back to its proper position and re-install the Food Pusher.
CAUTION SHARP
Blade
Blade
Locking
Screw
FIGURE 5
9