Device Installation - OPED VADOplex Mode D'emploi

www.oped.de | www.oped.ch

Device installation

To make the device ready for use, please read at first the safety
notes on page 4/5 before you follow the installation steps like
below from Step 1 to 5.
1. Plug the power plug into the power socket
2. Plug the respective connectors into the outlets
Plug the blue tube for the left pad into the left connection (blue).
Plug the green tube for the right pad into the right connection
(green).
3. Attach the pads properly. Connect controller tube
to pad tube.
Attach the VADOplex pads and make sure that they are positioned
properly (see user manual supplied with pressure sleeves). The
pads are to be used for one patient only and may neither be used
for several patients nor refurbished. Plug the metal pin of the
connector tube to the pad tube. Connect the blue tube for the left
pad to the blue tube of the controller (left). Connect the green tube
for the right pad to the green tube of the controller (right).
Device installation
4. Switch on the power switch
Note
(device initialization)
After switching on the controller, the
system starts the self-check and when
self-check is completed the device is
ready for operation and show on
the display:
Program 1
Foot
Program 2
Calf/Foot
Program 3
Hand
5. Press the Start/Stop button
After pressing the
Start/Stop button,
the following display
appears:
37