Manual Draining Of The Water Heater - Rinnai V94i Manuel D'installation Et D'utilisation

Manual Draining of the Water Heater

WARNING
If the water heater is not going to be used during a period of possible freezing weather, it is recommended that
the water inside the water heater be drained.
To manually drain the water:
1. Shut off cold water supply and gas supply.
2. Turn off the temperature controller.
3. Disconnect the power to the water heater.
4. Place a container to catch the water. Remove the drain caps on
both isolation valves and open both valves above the caps (blue
and red valve handles). -OR- Open the pressure relief valve.
5. Remove water filter to drain the cold water.
To resume normal operation:
1. Confirm that the gas supply is turned off, and that all taps are
closed.
2. Screw in the water filter in the cold water inlet.
3. Replace the drain caps and close both isolation valves. -OR- Close
the pressure relief valve.
4. Open the cold water supply.
5. Open a tap and confirm that water flows, and then close.
6. Turn on the power.
7. After confirming that the temperature controller is off, turn on the
gas supply.
8. Turn on the temperature controller.
Running a low volume of water through the water heater to prevent freezing
If the temperature exceeds the ability of the water heater to freeze protect itself,
or if power is lost, the following steps may prevent the water heater and external
piping from freezing. (Units connected with EZ Connect (2 unit link) should be
drained to prevent freezing if not in use.)
1. Turn the water heater off.
2. Close the gas supply valve.
3. Turn on a hot water tap to flow water about 0.1 gal/min or where the stream
is about 0.2 inches thick.
When the water heater or external piping has frozen
1. Do not operate the water heater if it or the external piping is frozen.
2. Close the gas and water valves and turn off the power.
3. Wait until the water thaws. Check by opening the water supply valve.
4. Check the water heater and the piping for leaks.
To avoid burns, wait until the equipment cools down before draining the water. The
water in the appliance will remain hot after it is turned off.
Value Series Manual
Hot water
outlet
ON!
COLD
HOT
0.1 gal/min or
about 0.2 inch
thick
Water
filter
Cold water
inlet
39