Assembling/Dismantling The Two-Piece Blow Tube; Assembling/Dismantling The Two-Piece Suction Tube - Grizzly ELS 3027 E Combi Traduction De La Notice D'utilisation Originale

GB
Caution, Risk of Injury! During
the assembly or disassembly of
the blower pipe, suction pipe,
protective cover or collection
bag, the engine must be turned
off and all moving parts must
have come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Assembling/dismantling the
two-piece blow tube
Never use the leaf blower with
only one blower tube section
attached. There is a risk of per-
sonal injury!
1. Assemble the two-piece blow
tube (9) as illustrated. The parts
can be felt to lock into place.
During assembly, make sure that
the groove on the upper section
of the blower tube is inserted into
the recess provided on the lower
section of the blower tube.
2. Now push the blow tube (9) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (8).
3. Place the protective cover of
the suction opening (7) on the
underside of the motor housing.
Turn the protective cover clock-
wise as far as it will go.
4. Attach the protective cover by ti-
ghtening the screw with star grip
(19) in the holder.
The screw with star grip has to
be tightened as far as it will go
by hand, as otherwise the leaf
blower cannot be started later.
72
5. Dismantle the blow tube (9) by
releasing the lock (8) and pulling
off the blow tube forwards.
Assembling/dismantling the
two-piece suction tube
Never use the leaf vacuum with
only one suction tube section
attached. There is a risk of per-
sonal injury!
After the two-part suction tube
has been assembled, it must
not be divided up again into two
parts!
1. Remove the protective cover of
the suction opening by unscrew-
ing the screw with star grip (19)
and turning the protective cover
anti-clockwise and removing it.
2. Assemble the two suction tubes
(17) as illustrated. The parts can
be felt to lock into place.
During assembly, make sure that
the groove on the upper section
of the suction tube is inserted
into the recess provided on the
lower section of the suction tube.
3. Assemble the wheels (16) by
sliding the wheel through the hole
of the wheel retaining bracket
(21) with the bolt and turning the
second wheel clockwise on the
wheel bolt.
4. Place the
the underside of the motor hou-
sing (1). Turn the suction tube
clockwise as far as it will go.
5. Attach the suction tube by tighte-
ning the screw with star grip (13)
in the holder.
suction tube (17) on