Working With The Leaf Blower - Grizzly ELS 3027 E Combi Traduction De La Notice D'utilisation Originale

GB
2. Connect the machine to the po-
wer supply.
3. To turn on, push the
on/off switch (4):
- in blow mode: to the right.
- in suction mode: to the left.
4. In order to regulate the suction/
blowing power, press the volume
control (2).
5. To turn off, push the
on/off switch (4):
- in blow mode: to the left.
- in suction mode: to the right.

Working with the leaf blower

The leaf blower may only be used
for the following purposes:
- As a blower to pile up dry leaf
material or to blow material out
of places that are hard to access
(e.g. under cars)
- As a suction device to suck up
dry leaf material. The device also
functions as a shredder in the
suction function. The dry leaves
are shredded and their volume is
reduced, preparing the material
for later composting if desired.
The shredding intensity depends
on the size of the leaf material
and its residual moisture.
Uses other than those described
here may damage the machine
and put the operator at risk.
During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do not
suck up any solid bodies such
as stones, branches or pieces of
branch, fir cones or similar, since
these can damage the device, in
particular the shredding mechanism.
74
Repairs of this type are not cov-
ered by the guarantee.
Blowing operating mode:
For safety reasons, make sure
that the protective cover (7) is
mounted on the suction opening.
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves ad-
hering to the ground with a broom or
rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
Suction operating mode:
For safety reasons, both suction
tube sections and the collection
bag must be correctly mounted
before you can start the device.
• Always hold the device tight with both
hands during operation: use the hand-
le (3) and the additional handle (10) for
this.
• Make sure the volumes of leaf material
sucked in at one time are not too large.
This will avoid clogging of the suction
tube (17) and blockage of the impeller
wheel.
To reduce wear on the collec-
tion bag, do not drag it along the
ground while working.