Cleaning And Maintenance; Cleaning; General Maintenance - Grizzly ELS 3027 E Combi Traduction De La Notice D'utilisation Originale

Overload protection: The motor will
cut out immediately if overloaded.
Turn the leaf vacuum off and re-
move the mains plug. Then check
whether the impeller is blocked or
the collection bag clogged and remo-
ve the obstacles if they are.
The tool cannot be used until it has
completely cooled down again.
Emptying the collection bag:
With full collection bag, the suction pum-
ping capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
1. Turn off the device and wait until
the impeller has stopped.
2. Unplug the device.
C D
3. Remove the attachment eyes
(15) from the holding points (20).
Release the collection bag by
L M N
pressing the locking button (8).
4. Open the zip-fastener on the
W X
collection bag and empty it com-
pletely.
5. Mount the emptied collection
bag again.
Composting material does not be-
long with domestic waste!
Cleaning and
maintenance
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might
prove impossible to remove without
dismantling the motor housing.
E F G
O P Q
Y Z
Such cleaning work is not
covered by the warranty.
Contact our Service Centre about
repairs and servicing not descri-
bed in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove
the mains plug
Do not use any cleaning agents
or solvents. Chemical substances
may attack the plastic parts of the
device.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

H I J
Do not spray the appliance with
R S T
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.

General maintenance

• Prior to every use, check the appliance
for obvious defects such as loose,
worn or damaged parts.
Check that the screws in the cutting
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
GB
75