Recharging The Battery; Used Batteries; Assembling Instructions; Operation - Grizzly ALB 1815 Lion Notice D'utilisation Originale

GB
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Recharging the battery

Recharge the battery when the last
charge state indicator LED (
changes from green to orange/red.
When starting to charge and while
charging, the battery charge indica-
tor ( 8) lights up red.
When charging is over, the light
changes to green.
1. Remove the battery (7) from the
appliance, as necessary.
2. Inser the battery (7) in the charg-
ing compartment of the battery
charger (8). It will audibly snap
in.
3. Plug the battery charger (8) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (8) from the mains.
5. Press the release button (9) on
the battery (7) and pull the battery
out of the battery charger (8).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").
46

Assembling instructions

Do not insert the battery until
the appliance is fully assembled.
Risk of injury!
Unit assembly:
10)
Slide the blower pipe (1) onto the connec-
tor nozzle (2) on the motor housing (4)
until it locks into place. In order to attach
the blower pipe (1), the locking button (3)
must be pressed down. There is a distinct,
audible clicking sound when the blower
pipe has attached to the locking button.

Operation

Please observe local regulations
concerning noise protection.

Turning on and off

Ensure you are standing solidly
and hold the device firmly and
away from your body. Before
switching the device on, ensure it
is not in contact with any objects.
1. Check that the battery (7) is in
(see "Charging the battery - Re-
moving/Inserting the battery").
2. To switch the device on, push
the on/off switch (5) forwards.
3. To switch the device off, push
the on/off switch (5) backwards.

Working with the appliance

Only use the device when the
blower pipe is attached!
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.