Recharging The Battery; Used Batteries; Initial Start-Up; Assembling/Dismantling The Three-Piece Blow Tube - Grizzly ALS 4025 Lion Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
GB

Recharging the battery

1. Remove the battery (5) from the
appliance, as necessary.
2. Inser the battery (5) in the charg-
ing compartment of the battery
charger (15). It will audibly snap in.
3. Plug the battery charger (15) into
a mains outlet.
The charging indicator lights up:
green LED flashes, red LED
lights up: Battery charging
green LED lights up:
Battery is charged
4. When the battery is fully re-
charged unplug the battery
charger (15) from the mains.
5. Press the release button (
19) on the battery (5) and pull
the battery out of the battery
charger (15).

Used batteries

If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Initial start-up

Before operating the equipment, you must
-
install the blower or suction pipes,
-
install the collection bag for suctioning
leaves,
Caution, Risk of Injury! During
the assembly or disassembly of
70
the blower pipe, suction pipe or
collection bag, the engine must
be turned off, the on/off switch
set on „0", and all moving parts
must have come to a standstill.
Assembling/dismantling the
three-piece blow tube
1. Assemble the three-piece blow
tube (14) as illustrated. The parts
can be felt to lock into place.
2. Now push the blow tube (14) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (13).
3. Dismantle the blow tube (14) by
releasing the lock (13) and pulling
off the blow tube downwards.
Assembling/dismantling the
three-piece suction tube
1. Assemble the three suction tubes
(10) as illustrated.
2. Press the locking switch (8) on
the device housing (1) to release
the protective cover (11) of the
suction aperture.
3. Remove the protective cover (11).
4. To mount the suction tube (10) in
the motor housing (5), push it into
the suction aperture. Make sure
that the guide lugs on the elbow
of the suction tube engage in the
recesses of the aperture. These
then lock into place.
Installing/removing the
collection bag
In suction mode the device can only
be operated with the collection bag
installed.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Als 4025 lion set

Table des Matières