Switching On/Off The Camera And The Monitor; Pairing - Conrad V2 Notice D'emploi

To extend the audio and video signal, only use suitably shielded
RCA cables. The use of other cables might cause disturbances.
Keep the length of the cables as short as possible.

7. Switching on/off the camera and the monitor

Hold down the "ON/OFF" buttons
camera and the monitor.
When the camera is switched on, the "POWER" LED (9) lights up.
When the receiver is switched on, the "POWER" LED (13) lights up.
The camera and the monitor can be switched off in the same way.
When the monitor is switched on, it automatically displays
camera channel 1.

8. Pairing

Note that the pairing function assigns the paired camera to the
respective camera channel. The camera previously assigned to
that channel is deleted.
By default, the provided camera is assigned to camera channel
1 of the receiver.
• Press "OK" on the multi-function button (14) of your receiver. The settings menu
opens up.
• Press the "Up"
function button (14) to select menu item "Pair CAM".
, "Left" , "Down"
(7, 19) for approx. 3 seconds to switch on the
, and "Right" sections of the multi-
37