Connecting The Wireless Camera; Connecting The Receiver/Monitor - Conrad V2 Notice D'emploi

6.2 Connection of the wireless camera
It is recommended to charge the built-in rechargeable battery of
the camera for 8-10 house before the first use to allow the batte-
ry to reach its full capacity.

6.3 Connecting the receiver/monitor

It is recommended to charge the built-in rechargeable battery of
the receiver for 8-10 hours before the first use to allow the bat-
tery to reach its full capacity.
• Connect the low voltage plug of the supplied
wall power supply with the "DC IN 5 V" (9) power
socket on your wireless camera.
• Plug the wall power supply into a suitable mains
socket.
• The "Battery" LED (2) lights up to indicate that
the built-in battery is being charged. The "Batte-
ry" LED (2) goes out when the battery is fully
charged.
• Connect the low voltage plug of the supplied
wall power supply with the "DC IN 5V" (21)
power socket on your receiver/monitor.
• Plug the wall power supply into a suitable mains
socket.
• The "Battery" LED (12) lights up to indicate that
the built-in battery is being charged. The "Batte-
ry" LED (12) goes out when the battery is fully
charged.
35