Connecting The Monitor With The Pc; Restore Factory Settings (Reset) - Conrad V2 Notice D'emploi

16. Connecting the monitor with the PC

Install the supplied software before connecting the monitor to the PC and using it.
Information on the installation procedure and the handling of the software can be
found in the operating instructions of the manufacturer, which can be found on the
CD-ROM in the folder "Manual".
* Connect the monitor to a free USB port of your PC/laptop with the supplied USB
connection cable.
* Start the successfully installed iSEC software.

17. Restore factory settings (RESET)

Press the "RESET" button (18) on the receiver/monitor to carry out a reset.
You can also carry out a reset by selecting "Factory Reset" in the settings menu and
then pressing the camera channel selection button
44
• Press the "Left"
section of the multi-function button
(14) to make the desired settings.
• Press "OK" on the multi-function but-
ton (14) to save the settings and exit
the "System Setup" menu.
(15).
or "Right"