FujiFilm instax mini LiPlay HM1 Guide D'utilisation page 10

Bluetooth® Devices: Cautions
EN
IMPORTANT: Read the following notices before using the
product's built-in Bluetooth transmitter.
■ Use only as part of a Bluetooth network.
FUJIFILM Corporation and its affiliates do not accept liability
for damages resulting from unauthorized use. Do not use
in applications requiring a high degree of reliability, for
example in medical devices or other systems that may
directly or indirectly impact human life. When using the
device in computer and other systems that demand a
greater degree of reliability than Bluetooth networks, be
sure to take all necessary precautions to ensure safety and
prevent malfunction.
■ Use only in the country in which the device was
purchased.
This device conforms to regulations governing Bluetooth
devices in the country in which it was purchased. Observe
all location regulations when using the device. FUJIFILM
Corporation and its affiliates do not accept liability for
problems arising from use in other jurisdictions.
■ Wireless data (images) may be intercepted by third
parties.
The security of data transmitted over wireless networks is
not guaranteed.
■ Do not use the device in locations subject to magnetic
fields, static electricity, or radio interference.
Do not use the transmitter in the vicinity of microwave
ovens or in other locations subject to magnetic fields, static
electricity, or radio interference that may prevent reception
of wireless signals. Mutual interference may occur when the
transmitter is used in the vicinity of other wireless devices
operating in the 2.4 GHz band.
10
■ The Bluetooth transmitter operates in the 2.4 GHz band.
The standard output is 3.16 mW.
■ This device operates on the same frequency as
commercial, educational, and medical devices and
wireless transmitters.
It also operates on the same frequency as licensed
transmitters and special unlicensed low-voltage transmitters
used in radio-frequency identification tracking systems for
assembly lines and in other similar applications.
■ To prevent interference with the above devices, observe
the following precautions.
Confirm that the radio-frequency identification transmitter
is not in operation before using this device. If you notice
that this device causes interference in low-voltage radio-
frequency identification tracing systems, contact a FUJIFILM
representative.
■ The following may be punishable by law:
– Disassembly or modification of this device.
– Removal of device certification labels.
■ Trademark Information
The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth SIG, Inc., and any use of
such marks by FUJIFILM is under license.