Mount The Bracket; Wiring - LiftMaster Cloud CAP2D Manuel D'installation

INTRODUCTION
4

Mount the Bracket

1. Install an electrical box in the desired mounting location.
NOTE: Use 4" square electrical box (minimum of 1 1/2" deep) with a single-gang plaster ring. Use Wiremold
BW35 for surface-mount installations.
2. Remove the bracket from the back of the CAP2D.
3. Mount the bracket to the electrical box.
4. Run all wiring to the electrical box.
5. Once all the wiring is completed, position the CAP2D in the bracket and secure it at the bottom with the provided screw.
PRE-INSTALL

WIRING

Bracket
NETWORK ACCESS CONTROL
Electrical Box
9
INSTALL
® V5744S or