Internet Service; Cp# For Controller; Setup A Liftmaster Cloud Account - LiftMaster Cloud CAP2D Manuel D'installation

INTRODUCTION
1

Internet Service

The controller MUST be configured with the proper network settings to operate.
NETWORK
Internet service provider:
Automatic IP addressing: DHCP (default setting)
OR
Static IP Addressing: Optional, requires connection to PC with USB (NOTE: Write down the following for future
reference: IP, Netmask, Gateway, Primary, Secondary, Server Port)
2

CP# for Controller

(Located on a label on the housing)
IPC - _ _ - _ _ _ _ _
3

Setup a LiftMaster Cloud Account

NOTE: If you have an existing MyQ
password.
1. If you do not have a LiftMaster Cloud Account, call LiftMaster Customer Care at 800.323.2276 to
activate a LiftMaster Hosted Cloud Service account.
2. You will get a welcome email from LiftMaster. Accept the email invitation and register or login to
your account.
3. Set up the Facility and add residents and credentials (refer to the available Help in LiftMaster
Cloud).
4. Continue with the installation of the CAP2D in this manual.
For LiftMaster Cloud programming please visit www.LiftMasterCloud.com.
PRE-INSTALL WIRING
® account, your LiftMaster Cloud account will have the same
NETWORK ACCESS CONTROL
IPC-XX-XXXXX
CP#
8
INSTALL