Canadian Spa North American 60Hz Mode D'emploi page 40

REPLACE A SPEAKER ON A HOT TUB
TOOLS NEEDED: Drill, Wire cutters, 5A Connection Strip x 2, Small flat screwdriver, insulation tape.
IMPORTANT: SWITCH OFF ELECTRICAL SUPPLY BY DISCONNECTING THE PLUG AT THE SOCKET OR ISOLATION SWITCH.
Please contact a qualified electrician if you need assistance or contact us at Canadian Spa
How to Guide
STEP 1 - Remove panel next to
faulty speaker
STEP 2 - Unplug white plug to
speaker light
STEP 3 - Cut Red wire and Red/
Black wires to speaker
STEP 4 - Using body of speaker
unscrew by turning anti-clockwise
(Note: the nut is 'silliconed' in
place')
Owners Manual
27
STEP 5 - Screw in new speaker
using body to tighten - removing
nut and using fixed nut to spa until
tight.
STEP 6 - Remove insulation from
speaker wires and join using 5A
connection block (Red to Red and
Black/Red to Black/Red)
STEP 7 - Insulate tape wires and
block before reassembly
STEP 8 - To re-assemble reverse
the above sequence: Steps 3 to 1