Canadian Spa North American 60Hz Mode D'emploi page 13

POWERING UP YOUR SPA
Once the spa is properly wired and filled with water, the spa power can
be turned on and Start-up chemicals added.
1. Turn on GFCI breaker. If breaker trips immediately check
wire connections. Upon initial power up, 4 sets of numbers flash
on the LED display of the topside Console. The last number in the
sequence is the incoming power meter which can be used to verify
that the spa is wired correctly.
2. The spa begins an automatic priming routine which will last 5
minutes ("Pr" is on the LED display).
3. The priming routine will automatically run each spa pump to
prime. When the "Pr" is displayed, press any PUMP button
to prime that pump or wait for the priming routine to turn
on the Pump. IMPORTANT: To avoid pump damage, do not run
pumps for more than 1 minute without moving water. If no water
is moving, turn the power off and perform air lock procedure.
4. The Topside Console display flashes "100F" then"--F" for
approximately 2 minutes to determine water temperature as it
flows through the heater.
5. The default pre-set temperature is 100F The last measured
temperature is constantly displayed on the LCD readout. This
temperature will be current only when the pump has been
running for at least 2 minutes. Set the desired temperature
between 80-104°F (26- 40°C) by pressing the temp button(s).
If the water temperature is below the set temperature, the spa's
heater and heat indicator light will turn on. All features of
the Topside Console will be available. The spa will heat
approximately 1° every 30 minutes per 1,000 litres.
6. Check for leaks! Although spas are fully checked at the factory,
shipping & delivery might cause a leak. Remember to pay
particular attention to barrel unions adjoining the heater.
Contact your Canadian Spa dealer directly if there is a problem.
If your new spa pump does not prime (flow) on the initial start-up you
may be experiencing an "air lock".
This normal occurrence can be easily corrected by loosening the
plumbing union on the suction side of the Jet or Circulation Pump until
water flows into the pump and all air is expelled.
PRESS BUTTONS SLOWLY FOR FIRST RUN WHEN STARTING UP
ONCE PR EXITS, SET TEMPERATURE ON SPA (SEE SPA OPERATION
SECTION FOR DIFFERENT SPA TOPSIDES)
Owners Manual
Starting your hot tub/spa
12
The above photograph refers to plug and play models only