Canadian Spa North American 60Hz Mode D'emploi page 39

REPLACE AN AMPLIFIER ON A HOT TUB
TOOLS NEEDED: Drill, Phillips CH3 screwdriver, Wire cutters, insulation tape, 4 x 5A connection strips, small flat screwdriver.
IMPORTANT: SWITCH OFF ELECTRICAL SUPPLY BY DISCONNECTING THE PLUG AT THE SOCKET OR ISOLATION SWITCH. Please contact a
qualified electrician if you need assistance or contact us at Canadian Spa
How to Guide
STEP 1 - Remove panels below
Touch pad (to get access to MP3
panel housing on/off button)
STEP 2 - Unscrew nut and then
unplug on/off connection from
amplifier
STEP 3 - Remove wiring from MP3
housing.
STEP 4 - Disconnect power supply
lead from amplifier by pulling plugs
apart.
STEP 5 - Cut Black/Red and Red
wires on amplifier wires.
Owners Manual
26
STEP 6 - Unscrew amplifier from
cabinet.
STEP 7 - Re-screw NEW amplifier
onto cabinet
STEP 8 - Remove insulation cover
from wires.
STEP 9 - Insert wires into 5A
connection blocks (Red to Brown
and Red/Black to Grey).
STEP 10 - Insulate tape connector
and wire