Canadian Spa North American 60Hz Mode D'emploi page 36

Change a floating Wier style skimmer filter
IMPORTANT: SWITCH OFF ELECTRICAL SUPPLY BY DISCONNECTING THE
PLUG AT THE SOCKET OR ISOLATION SWITCH. Please contact a qualified
electrician if you need assistance or contact us at Canadian Spa.
TIP: CLEANING YOUR FILTER
It is advisable to clean your hot tub filters every 2 or 3 weeks.
• Turn off spa power
• Remove the cartridge from the filter housing and use a
garden hose or a tap to wash down the filter. Rinse until all
dirt and debris have been removed.
• Dissolve 250 gms of Canadian Spa Filter Free in 10 litres of
luke warm water (one capful holds approximately 30 gms).
USE A PLASTIC PAIL AND MIX UNTIL THE SOLUTION TURNS
RED (ALWAYS READ THE LABEL). Soak the filter cartridge
CHANGE A GRATE FILTER ON A CANADIAN SPA TUB
Step 1. Remove the two screw cap
covers
Step 2. Undo the two screws to
release filter lid
Step 1. Removing the basket and
filter can be done with or without
water in the spa/hot tub (Tip: when
lifting filter from water have a net or
sieve in hand to catch any residual
dirt).
Step 2. To lift basket turn
counter-clockwise until the flat part
of the basket aligns with the flat part
of the filter housing
Step 3. Lift out the basket
Step 4. Remove the old filter
Step 5. Replace with the new filter
Owners Manual
Change a Wier style skimmer filter
for at least 1 hour (overnight is recommended).
• Rinse the cartridge again after cleaning to remove any
traces of cleaning solution.
• Always dry the filters before inserting them back into your
hot tub. This ensures that the filters perform to their best
and last longer. Let them dry naturally. It is also a good idea
to keep a spare set of filters.
• Do not run spa without filters
To order more filters call 1-877-347-7727 or visit our website:
www.canadianspacompany.com
23
Step 3. Open the filter lid to
access the filter chamber
Step 4. Unscrew the two filters and
replace with the new filters and
rescrew into position.
INSET PHOTO: Shows pre-filter
installed
Step 1. Remove the filter cover by
sliding up the front plate
Step 2. Remove the filter tray in
order to access the filter
compartment.
Step 3. Remove the old filter(s) by
unscrewing them
Step 4. Replace with the new
filter(s) and rescrew filter(s)
Step 5. Ensure the filter tray fits
in between the runners and slides
back in place. Note: Follow the same
process for a single port filter.
NOTE FOR SWIM SPAS:
Change the two filters stacked one
on top of each other. Bottom filter is
threaded and the top filter is push fit