Preparing The Enclosure; Required Tools - Danby Silhouette DWC140D1BSSPR Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 23.4 inches (59.5 cm) wide
by 69.8 inches (177.3 cm) high by 28.6 inches
(72.7 cm) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
1.5 in (3.8 cm) diameter
70 in
*If electrical outlet in
(177.9 cm)
adjacent cabinetry
Electrical Access Electrical Access
25 in
(63.5 cm)
24 in (61 cm)

PREPARING THE ENCLOSURE

Gloves and safety goggles should be worn during
installation.
It is not recommended to install the appliance into a
corner or directly beside a wall. The door will need
to be opened more than 90° to allow full extension
of the shelves. If it is necessary to place the unit next
to a wall or in a corner, leave at least 2-4 inches (5-
10 cm) of space between the wall and the appliance
to allow for the door opening.
The cabinet opening must be at least 24 inches
(61 cm) wide by 70 inches (177.9 cm) high by 25
inches (63.5 cm) deep.
Note: The listed depth requirement is assuming
that the electrical outlet is located in the adjacent
cabinetry or fl ush mounted in the rear wall, not
surface mounted inside the enclosure.
If the electrical outlet is located inside adjacent
cabinetry, cut a 1.5 inch (3.8 cm) diameter hole to
admit the power cord. If the cabinet wall is metal,
the hole edge must be covered with a bushing or
grommet.
2 in (5 cm)
6 in
(15.2 cm)
90°
3

REQUIRED TOOLS

• Safety goggles
• Gloves
• Tape measure
• Carpenter square
• Level
• Flashlight
• Electric drill with hole bit