Installation Instructions; Tools You Will Need; Preparing The Enclosure - Danby Silhouette DWC2727BLS Guide Du Propriétaire

Installation Instructions - Intergrated Application
Tools You Will
Need
FOR YOUR SAFETY:
While performing installations
described in this section,
gloves, safety glasses or
goggles should be worn.
Preparing the
Enclosure
Electrical Requirements:
The appliance must
connected to an individual
properly grounded electrical
outlet, protected by a 15 or 20
ampere circuit breaker or time
delay fuse.
*The listed depth requirment for the installation is assuming that the electrical outlet is located in the
adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
Safety Glasses
Drill & Hole Saw set
• It is recommended that you do
not install the wine cooler into a
corner (i.e. directly beside a
wall). This is to allow the door(s)
to have a greater then 90°
opening swing. A limited door
swing will prevent the shelves
be
from sliding out as intended, and
may lead to damaging the door
gasket(s).
• The rough cabinet opening
must be on a level floor area and
at least 24" deep* by 24" wide.
The opening should also have a
height of at least 34-1/2".
Fig C
34-1/2"
From
Underside
of
Countertop
to Floor
8
Gloves
Measuring Tape
• The electrical outlet may be
positioned from within either side
of the adjacent cabinetry, or the
rear of the shaded area (as
shown in Fig C.).
Important: If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirment for the installation
may be affected.
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2" diameter hole to admit
the power cord.
1-1/2" dia. hole
*if electical outlet
is in adjacent
cabinetry
24"
Min*
2"
Electrical Access
6"
24"
Level
Flashlight
Carpenters
Square
Cabinets
Square
and
Plumb