Operating Instructions; Setting The Temperature - Danby Designer DWC310BLSDD Guide D'utilisation Et Soins De Propriètaire

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

CONTROLS OF YOUR

WINE COOLER

To start the wine cooler, turn the temperature control to

the position corresponding to your desired cooling level.

The wine cooler temperature will vary depending on the

quantity of bottles stored, and on the frequency with

which the door is opened.

SETTING THE TEMPERATURE:

The temperature of the wine cooler compartment is con-

trolled by adjusting/setting the thermostat control knob,

located on the exterior rear wall of the unit. To start the

wine cooler and achieve maximum cooling quickly;

• Turn the temperature control knob clockwise to the

furthest (maximum) setting on the darker blue (wide)

section of the graduated control dial.

• Allow the unit to run at this setting for 3-4 hours.

• When maximum cooling is achieved, turn back the

temperature control knob to a desired setting on the

graduated blue control dial. See Fig.1.

• To turn off the wine cooler (no cooling) rotate the

control knob to the "0" (off) position. See Fig. 2. Turn

the control to the "OFF" (0) position to temporarily

disconnect the cooling cycle. When the wine cooler is

not to be used for long periods of time, disconnect

from power and leave the door partially open.

Fig. 1

NOTE: Wait 3 to 5 minutes before restarting if operation

has been interrupted.

Interior Light:

To manually operate the light, depress the interior light

toggle switch situated on the left side of the interior light

housing, located on the ceiling inside the unit; this will

allow the interior light to remain on while the door is

closed.