Setting The Temperature - Danby DWC032A2BDB Guide D'utilisation Et D'entretien

Operating Instructions
CONTROLS OF YOUR
WINE COOLER
To start the wine cooler, turn the temperature control to the position corre-
sponding to your desired cooling level. The wine cooler temperature will
vary depending on the quantity of bottles stored, and on the frequency with
which the door is opened.
SETTING THE TEMPERATURE:
The temperature of the wine cooler compartment is controlled by adjust-
ing/setting the thermostat control knob, located on the exterior rear wall of
the unit. To start the wine cooler and achieve maximum cooling quickly;
• Turn the temperature control knob clockwise to the furthest (maximum)
setting on the darker blue (wide) section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the temperature control
knob setting to the middle position on the graduated blue control dial. See
Fig.1.
• To turn off the wine cooler, (no cooling) rotate the control knob to the "0"
(off) position. See Fig. 2. Turn the control to the "OFF" (0) position to tem-
porarily disconnect the cooling cycle. When the wine cooler is not to be
used for long periods of time, disconnect from power and leave the door
partially open.
MAX
Fig. 1
NOTE: Wait 3 to 5 minutes before restarting if operation has been inter-
rupted.
Interior Light:
To manually operate the light, depress the interior light toggle switch situat-
ed on the left side of the interior light housing, located on the ceiling inside
the unit; this will allow the interior light to remain on while the door is
closed.
DEFROSTING: Your wine cooler is designed with an "Auto-Cycle"
defrost system. What is Auto Cycle defrost?
The refrigerated surfaces of the fresh food compartment defrost automati-
cally during the "off" cycle of the cold control (thermostat). Defrost water
from the compartment is disposed of automatically, by means of being
channeled onto a drip tray located on the compressor. Heat transfer from
the compressor causes the defrost water to evaporate.
6
MIN
MAX
Fig. 2
MIN