Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
SETTING THE TEMPERATURE
The temperature of the wine cooler is controlled by adjusting the thermostat control knob on the back
of the unit. To achieve maximum cooling temperature quickly:
•
Turn the temperature control knob clockwise to the widest, darkest part of the graduated blue
control dial.
•
Allow the unit to run at this setting for 3 - 4 hours.
•
When maximum cooling is achieved, turn the temperature control knob to the middle position on
the graduated blue control dial, as per Fig. A.
•
To turn the wine cooler off, turn the control knob to the "0" position, as per Fig. B. If the wine cooler
will not be used for an extended period of time, it is recommended to unplug the unit and leave the
door partially open to avoid possible formation of odors inside the unit.
Note: On the graduated blue dial, the thicker, darker blue indicates colder temperatures and the
thinner, lighter blue indicates warmer temperatures. The wine cooler temperature will vary depending
on the quantity of bottles stored in the unit and the frequency that the door is opened.
LIGHT BULB
The DWC350BLPA comes with a standard light bulb. To replace the bulb:
•
Remove the screw holding the light bulb cover and remove the cover.
•
Unscrew the light bulb and replace the bulb.
Note: Ensure the new light bulb does not exceed 15 watts.
The DWC350BLP comes with an LED light. To replace the LED light strip:
•
Remove the two screws holding the light bulb cover and remove the cover.
•
Remove the two screws holding the LED light strip.
•
Contact Danby consumer care for information on purchasing a replacement LED light strip.
DEFROST
This unit is equipped with a cycle defrost function and does not require manual defrosting. Defrost
water from the unit is channeled into a drip tray located above the compressor. Heat transfer from the
compressor causes the defrost water to evaporate.
6
Publicité
Table des Matières
